Advertisement
Inside freezer compartment
'0
Step
9
Remove screw (A) that holds electri-
cal plug cover in place. Discard screw
and cover.
Step 10
Remove plastic insert (B) from air
duct and discard it.
Loosen two icemaker mountina
Step 11
Cut the fill tubeextension
(5)tO
t h e n
length with a sharp knife or single
edge razor blade and slide it on the fill
tube against the stop.
Step
12
Place icemaker in freezer compan-
ment as shown. Insert icemaker power
cord plug (D) into socket
on
side wall,
making sure prongs are matched
to
corresponding holes and plug is firmly
seated in socket.
Step
14
The icemaker should feel
secure
when
you lift the icemaker feeler arm (F)
to
the "OFF" (up) position. Leave
it
there
until the refrigerator is connected to
the water SUDDIY to prevent Dremature
operation.
Step
13
Lift icemaker and position rear open-
ing in fill cup
(E) over fill tube ex-
tension (5). Hang icemaker on two
screws (C).
Make sure:
electrical plug
is still firmly in
socket.
fill tube extension (5) is still in fill
cup opening-check rear of refriger-
ator to make sure fill tube has not
been pushed out
of the back of the
refrigerator.
icemaker mounting screws are lo-
cated in uppermost position of mount-
ing slots.
ING SCREWS SECURELY
THEN TIGHTEN ICEMAKER MOUNT-
Step 15
Replace freezer shelf. Move bucket
support and ice bucket (7) into place
directly under the
icemaker. See
illustration below.
NOTE: Check again to make sure the
icemaker power cord plug is fully in-
serted Into its socket with prongs
matched
to
corresponding holes.
Check again to make
sure
the i c e
maker
feeler arm (F) Is In the "OFF"
(UP)
P W R h .
Step 16
A label (8) is provided in the
kit
to record
the date of installation for warranty
purposes. Apply it to the back of the
refrigerator.
Step 17
The
warranty for
the lcemaker is printed
on the back page of this booklet. Keep
this booklet with your Retrigerator Use & Care book.
The icemaker installation
is
now
complete. Refer
to
water line hook-up instructions
on the back of the refrigerator
for
connection
to
home water supply. After water line
installation is completed, lower icemaker feeler arm to the "ON" (down) position.
The icemaking cvcle will not begin unt/l the icemaker and freerer compartment
reach operating temperature, then icemaking will begin automat/callly.
11
Advertisement
