Installation; Drilling The Support Surface And Fitting The Hood - Smeg SHC965X Instruction Manual

INSTAllATION

Drilling the Support surface and Fitting the Hood

The Hood can be fitted directly to the underside of the Wall units (min. 650 mm above the cooker
top) with snap-on side supports, which are set up for a support panel thickness of between 15 mm
and 30 mm.
• Cut a fitted opening in the bottom surface of the
wall unit, as shown.
• Remove the metal grease filters (see par. on
Maintenance).
• Remove the filter support
• Disconnect the filter support by turning the internal
handles provided.
• Insert the hood until the side supports snap into
place.
• Lock in position by tightening the screws Vf
from underneath the hood.
• Replace the filter support
• Screw the filter support using the 2 screws
provided.
• Replace the grease filters make sure that the
handle is visible on the outside.
GB
12c
Vf
4