Maytag Neptune Washer Use And Care Manual page 8

U C
SING THE ONTROLS
S C
ELECT YCLE
Press the appropriate pad(s) to select one or more options.The indicator light above
the pad will illuminate when the option is selected.
Prewash (select models) – Can be selected with any cycle. Add detergent to the pre-
wash section of the detergent compartment.Washer fills with cold water and deter-
gent, tumbles for 25 minutes, then drains and advances to the selected cycle.
Stain Treat (select models) – Adds 5 minutes to the wash for better stain removal.
Extra Rinse – Adds an additional rinse at the end of the cycle to more thoroughly
remove laundry additives and perfumes.
Extended Spin (select models) – Adds additional time to the spin to remove more
water from the load.
Rinse and Spin – Use for loads that need rinsing only or to add rinse-added fabric
softener to a load.
Spin Only – Provides a spin to remove more water from the load.
Step 6
S W
TART THE
To start the washer, press the Cycle Selector dial. Before the washer starts to fill,
it will make a series of clicking noises to check the door lock and do a quick drain.
Changing a Cycle
If an incorrect cycle has been accidentally selected:
1. Press the Cycle Selector dial.
2.Turn the Cycle Selector dial to the desired cycle.
3. Set the desired options for the cycle.
4. Press the Cycle Selector dial.The Wash indicator
lights stop flashing and the new cycle starts.
Canceling a Cycle
To cancel a cycle:
1. Press the Power Off pad.
2. Select the Rinse and Spin or Spin Only option pad.
3. Press the Cycle Selector dial.The Spin light illuminates
and the washer starts the rinse or spin.
O , .
PTIONS CONT
ASHER
7
Control features vary by model.