Table of Contents
Advertisement
3.
Remove the liquid material vat.
Liquid material vat
MEMO
•
Before removing the liquid material vat, it is recommended to wash the printing platform
removed first, resin stuck to the printing platform may fall off and dirty the machine.
•
When removing the liquid material vat, take care not to spill any remaining resin on the machine.
•
Transfer any remaining resin from the liquid material vat to a beaker or similar container, let it cure, and then dispose of it according to local waste sorting
criteria.
4.
Soak a rag in ethanol and wipe any resin from the liquid material vat.
5.
Scrape off any cured resin that has stuck to the liquid material vat using the included plastic spatula.
NOTE
Use the plastic spatula to clean the liquid material vat. If the metallic spatula is used to clean the liquid material vat, the bottom of the vat (silicon material) may be
scratched, making it impossible to print.
6.
Dry the liquid material vat completely.
7.
Install the liquid material vat as before (p. 21).
("Wash printing platform"
40
Maintenance
(p. 36)). If the liquid material vat is
Advertisement
Table of Contents
