Table of Contents
Advertisement
Finish the job
As the resin will not have cured sufficiently immediately after printing, light is applied to complete the curing process. This procedure is known as
post-cure procedure can be achieved using sunlight, but it is also possible to use a commercially available post-cure device. Remove the supports after completing
the post-cure procedure.
Finishing the job involves removing supports and additionally curing the resin using a commercially available post-cure device (UV curing device).
MEMO
Use a post-cure device with the following specifications:
Specification
Light source wavelength
Output power
Post-cure time
Recommended value
380 to 405 nm
10 mW/cm
2
3 to 5 minutes
34
Output (Printing)
"post cure."
The
Advertisement
Table of Contents
