Installing/Removing Front-Mounted Handles For Stainless Steel - Maytag Refrigerator User Manual

Installation
Installing Front-Mounted Handles for
Stainless Steel
Removing Front-Mounted Handles for
Stainless Steel
1. Loosen lower door clip on door with
'/4" hex nut driver.
1. Remove plastic button plug at
base of handle with a very small
flat-blade screwdriver.
• Insert '/4" hex nut driver into
predrilled hole to remove
screw.
2. Locate predrilled hole at base of
handle, and fit hollow end of
handle over lower door clip.
3. Fit other end of handle over upper
door clip and slide up as far as
possible.
NOTE: If top of handle does not
fit over top clip, loosen lower clip
further until fit can be
accomplished.
4. Insert '/_" hex nut driver into
predrilled hole at base of handle
to tighten screw. Insert screw
plug into hole, as illustrated.
5. Repeat above steps to install
other handle.
2. Slide handle down and remove
from bottom door clip.
3. Repeat above steps to remove
other handle.