Bottom Of Cabinet Front Roller Assembly; Rear Roller Assembly; Condensate Drain Pan; Machine Compartment Condenser Fan & Fan Motor - Maytag ATB1504ARQ Service Manual

Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Bottom of Cabinet
Front Roller Assembly
1. Remove toe grille by either unscrewing or pulling it
straight away from unit.
2. Raise front of refrigerator at least 4" off the deck and
block it up.
3. Remove screws holding roller assembly to unit.
4. Remove roller assembly from unit.
NOTE: Condensate drip pan may be full when steps 1
thru 2 are performed. Remove Condensate drip
pan to prevent spillage.

Rear Roller Assembly

1. Tape both doors shut to prevent doors from opening
2. Raise back of refrigerator at least 4" off the deck and
block it up.
3. Remove machine-compartment cover.
4. Locate and cut roller pins with hacksaw or grinder.
5. Install new rollers and install new pins pinch
6. Pinch end of pin to prevent pin from coming out of
bracket.
NOTE: Condensate drip pan may be full when steps 1
thru 2 are performed. Remove Condensate drip
pan to prevent spillage.

Condensate Drain Pan

1. Remove Toe Grill
2. Drain pan is then visible and can be unsnapped from
cabinet bottom and pulled forward to remove it.
3. Remove drain pan.
Machine Compartment
Condenser Fan & Fan Motor
1. Remove machine compartment cover.
2. Unplug wiring harness connector for the fan motor.
3. On backside of fan motor, screws secure the motor to
its brackets. Remove those screws.
4. Note which side of fan blade is "front" and which side
is "rear." Then use pliers to loosen nut that secures
fan blade to motor shaft. Remove nut and fan blade.
16022675
!
WARNING

Compressor

Protect all plastic side walls of Machine Compatment
from Torch Flame with Heat Shield.
NOTE: Install new drier and compressor per
instructions in "Service Procedures." Evacuate
and recharge sealed system per instructions in
"Service Procedures."
1. Remove machine compartment cover.
2. Remove drier.
3. Disconnect all compressor wiring and overload/relay
assembly.
4. Unbraze low and high pressure lines at compressor.
5. Remove compressor mounting pins.
6. Lift compressor out of unit.

Overload/Relay/Capacitor

1. Remove machine compartment cover.
2. Using fingers and standard screwdriver, press and
pry bale strap off the overload/relay assembly
3. Disconnect wires from overload/relay assembly.
Reference wire location.
4. Unplug overload/relay assembly from compressor.

Condensate Drain Tube

1 Condensate Drain is foamed in liner and is not field
replaceable.

Condenser Removal

NOTE: Install new drier per instructions in "Service
Procedures." Evacuate and recharge sealed
system per instructions in "Service Procedures."
1. Remove machine compartment cover.
2. Unbraze tubing going to PC loop and heat exchanger.
3. Disconnect Condenser Fan electrical plug.
4. Tape both doors shut to prevent doors from opening
5. Raise back of refrigerator at least 6" off the deck and
block it up.
6. Remove Philips head screws to base pan and lift and
slide condenser out back of unit.
28
©2003 Maytag Appliances Company