Temperature Control; Selector Switch - GE Carry Cool ATL04 Use And Care & Installation Manual

SELECTOR

Selector Switch

OFF turns air conditioner off.
HI FAN provides high fan speed
operation without cooling.
LO FAN provides low fan speed
operation without cooling.
HI COOL provides cooling with
high fan speed operation.
LO COOL provides cooling with
low fan speed operation.
For normal cooli~
1. Set Selector Switch at HI COOL.
2. Set Temperature Control at
desired number (usudy the midpoint
is a good starting position). If room
temperature is not satisfactory aftera
reasonable time, set the Temperature
Control at a higher number for a
cooler room or at a lower number
for a warmer room.
For mafimum cooli~
1. Set Selector Switch at HI COOL.
2. Set Temperature Control at 8.
THERMOSTAT
5
4
'

Temperature Control

When you turn the Temperature
Control to the desired setting, the
thermostat will automaticdl~ control
the temperature of the indoor air.
The higher the number selected, the
cooler the indoor air will be.
For quieter operation
1. Set Selector Switch at LO COOL.
2. Set Temperature Control at
desired number.
When the Temperature Control is
set on 7 or 8 and the Fan is set on low
speed, moisture may freeze on the
coils and prevent the unit from
cooling. If this happens, set the Fan
at high speed and set the Temperature
Control to a lower number.
For air circulation and
Set the Selector Switch at LO FAN
or HI FAN.
Moisture removal
removes from theairdrains to the rear
of the cabinet where it is picked up
by a fan and dispersed against the
condenser. Occasiondy, more likely
during start-up, a "pinging" noise
may be heard. This is normal for a
short time in less humid areas and
longer in very humid areas. This
method ofmoistureremovd improves
the operational efficiency of your
air conditioner.
Note: Before moving your air
conditioner to another location,
turn it off and wait 5 or 10 minutes.
This will allow the condensate to
drain from the coil into the base
pan. Then, keeping a firm grip on
the air conditioner, carefully raise the
window and tilt the air conditioner
to the outside to drain the water
from the base pan.