Drying Tips - GE DDE9500M Use And Care Manual

Push a button to select the proper heat for your load.
Fluff
No Heat
(Operates only with Automatic,
Turn to ON if desired.
Care cycle provides approximately
15 minutes of no-heat tumbling
after the clothes are drv.
Use End-of-Cycle Signal. Signal
will sound at five-minute intervals
to remind you to remove the clothes.
End-of-Cycle Signal
(Operates with any cycle.)
The Signal control can be set
anywhere between OFF and
LOUD, depending on desired
sound level. The signal will sound
just before the end of the cycle to
remind you to remove the clothes.
To stop signal while sounding, turn
Signal control to OFF or advance
Cycle Selector to OFF.
The Signal should always be used
when drying Polyester Knits or
Permanent Press items which
should be removed as soon as the
dryer stops to help prevent setting
of wrinkles.
The signal should also be used with
the Extra Care Cycle.
Should be used with cvcles indicated .
Automatic,
Knits Cycles
desired. (See below.)
–
To minimize '
cycle setting. The selector may be
turned in either direction.
to start dryer. (Opening the door
during operation stops the dryer. To
the START button. )
Polyester Kni@ &
Permanent Press

drying tips

DO NOT OVERLOAD—
Garments being dried or
REMOVE CL~HES
wrinkling, remove from the dryer
promptly at the end of f~e drying
cycles.
. PLACE ON HANGERS—
Permanent Press and Polyester
Knit garments look best if placed
on hangers after drying.
What is the difference
between ~med &
Automatic drying?
Timed Drying
Timed
When using the TIMED ~CLES,
Cycles
you select the number of minutes
you wish the dryer to run and it
turns off at the end of this time
period.
Automatic Drying
When using the Automatic Cycles,
the Electronic Sensor Control
system continually senses the
moisture in the tumbling clothes,
determines when they are dried to
your pre-selected setting, and
terminates the cycle automatically.
Refer to the CONTROLS SETTING
GUIDE for recommended settings.
The Cycle Selector will not advance
until clothes have reached a certain
degree of dryness.
Dryness selections guide for
the automatic cycles
5
Set to Middle Position
For most normal loads.
Set
toward MORE DRY
.
For loads that include heavy-
weight fabrics.
If you desire to remove more
moisture.
Set toward LESS DRY
OFF
For lightweight fabri~loads.
If you desire to remove less
moisture.
For very small loads.