End-Of-Cycle Signal; Extra Care Cycle; Automatic Drying; Drying Tips - GE DDE8506M Use And Care Manual

Push a button to select the proper heat for your load.
Fabric Care
Selections
Cottons
High Heat
Perm
Press
Medium Heat
Low Heat
Fluff
No Heat
(Operates only with Automatic,
Perm Press& Knits Cycles.)
Turn to ON if desired. To minimize
Care cycle provides approximately
after the clothes are dry.
Use End-of-Cycle Signal. Signal
will sound at five-minute intervals
to remind you to remove the clothes.

End-of-Cycle Signal

(Operates with any cycle.)
The Signal control can be set
anywhere between OFF and
LOUD, depending on desired
sound level. The signal will sound
just before the end of the cycle to
remind you to remove the clothes.
To stop signal while sounding, turn
Signal control to OFF or advance
Cycle Selector to OFF.
The Signal should always be used
when drying Polyester Knits or
Permanent Press items which
dryer stops to help prevent setting
of wrinkles.
The signal should also be used with
the Extra Care Cycle.
Should be used with cycles indicated
Automatic,
Automatic Perm Press and
Regular Cycle Knits Cycles
desired. (See below.)
cycle setting. The selector may be ~~' ~A~'Refer t. tie CONTROLS
turned in either direction.
to start dryer. (Opening the door
during operation stops the dryer. To
the START button. )
Polyester ~ib &
Permanent Press

drying tips

DO N~ OVERLOAD—
Garments being dried or
REMOVE CLOTHES
promptly at the end of the drying
cycles.
Permanent Press and Polyester
Knit garments look best if placed
on hangers after drying.
What is the difference
between ~med &

Automatic drying?

Timed Drying
Timed
When using the TIMED CYCLES,
Cycles
you select the number of minutes
you wish the dryer to run and it
turns off at the end of this time
Automatic Dryin$,. ~.i.
When using the~tomatlc Cycles,
the ~
until clothes have reached a certain
degree of dryness.
Dryness selections guide for
the automatic cycles
5
SETTING
Set to Middle Position
.
For most normal loads.
Set toward MORE DRY
OFF
,
For loads that include heavy-
weight fabrics.
If you desire to remove more
moisture.
Set toward LESS DRY
.
4
For lightweight fabric loads.
If you desire to remove less
moisture.
. For very small loads.