Automatic Drying; Extra Care Feature; Knits Drying Tips; Timed Drying - GE DDP1370G Use And Care Manual

read the IMPORTANT SA~TY INSTRUCTIONS before operating this appliance.
Load sorted clothes into dryer
following instructions on page 5.
Close door. Door must be closed
before dryer will operate.

Controls Setting Guide

Cycle
Normal & Permanent Press
Setting
Fabric
Cottons Permanent
& Linens
(High Heat)
The times suggested above are to be followed as a guide. You may find that best results are obtained for some of
your fabrics by setting times to either side of these recommendations.
Dryness selections guide
for the automatic cycles
Set to
Middle Position
For most normal loads.
.
Set toward
MORE DRY
For loads that include (
heavyweight fabrics.
If you desire to remove more moisture.
Set toward
LESS DRY
For lightweight fabric
loads.
If you desire to remove less moisture.
the risk of fire, electric shock, or injury to persons,
Set the Controk
See Controls Setting Guide below.
cycle.
to appropriate setting.
Knits 3040 min.
Synthetic
Knits Sheers
& Blends
Delicate
Knits
(Med. Heat) (Low Heat)
Minimize Wrin~e-Setting
When the Cycle Selector reaches
Clothes can be removed at this
point or at any time during the
EXTRA CARE cycle. Following
the drying cycle, EXTRA CARE
automatically provides no-heat
tumbling to minimize wrintiing.
TIMED CYCL=
40-W 20
Time
min.
min. Desired
Plastics,
Avg. Load
Cottons
of Mixed Rubber
(Damp
Cottons Dried for Dewrinkling
Ironing)
Fluff
(High Heat)
TIMED CYCLES
PRESS
TEMPERATURE TO START
momentarily. (Opening door
during operation stops the dryer.
Tore-start, close the door and push
START button again.)
. Do not overload—Garmen@
being dried or dewrinkled should
tumble freely.
Remove clothes immediately—
To help prevent wrintiing, remove
from the dryer immediately at the
end of the drying cycles.
Place on hangers-Permanent
Press and Polyester Knit garments
look best if placed on hangers after
drying.
How ~med and Automatic
Drying Differ
Automatic drying-The Automatic
Dry Control system contindy senses
air temperature in dryer drum. Wet
laundry keeps this air cool. When
drum air is warm enough, heat turns
off. When the air cools, heat turns
back on. This on and off cycling may
happen a number of times (depending
on the fabric, load size and Cycle
Selector setting). The Cycle Selector
advances (when the heat is ofo until
it automatically turns dryer off.
Timed drying—You select the
number of minutes you wish the
dryer to run and it turns off at
the end of this time period.
7