In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
�
the State of Massachusetts.
If using a ball valve, it shall be a T-handle type.
�
A flexible gas connector, when used, must not exceed 3 feet.
�
Tools and Parts
Gather the required tools and parts before starting installation.
Tools needed for all installations:
Flat-blade screwdriver
1/4" nut driver or socket
wrench (recommended)
Tape measure
Level
4
IMPORTANT SAFETY INSTRUCTIONS
When discarding or storing your old clothes dryer, remove the door.
SAVE THESE INSTRUCTIONS
INSTALLATION REQUIREMENTS
#2 Phillips screwdriver
Tin snips (new vent
installations)
Vent clamps
Pliers
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife
Tools needed for gas installations:
8" or 10" pipe wrench
Pipe-joint compound
resistant to LP gas
Caulking gun and compound
(for installing new exhaust vent)
8" or 10" adjustable wrench
(for gas connections)