Deskset Installation - VTech ErisTerminal VSP725 Quick Start Manual

Deskset Installation

This section assumes that your network infrastructure is established and that
your IP PBX phone service has been ordered and configured for your location.
For more information about installation options and phone setup, see the
VSP725 Deskset User Guide and the VSP725 Deskset Administrator and
Provisioning Manual, available at
You can power the phone using a compatible VTech power adapter or using Power
over Ethernet (PoE) from your network. (The phone requires PoE Class 2.) If you
are not using PoE, install the phone near a power outlet not controlled by a wall
switch. The phone can be placed on a flat surface or vertically mounted on the wall.
Avoid placing the deskset too close to:
• Communication devices such as television sets, DVD players, or other
cordless telephones
• Excessive heat sources
• Noise sources such as a window with traffic outside, motors, microwave
ovens, refrigerators, or fluorescent lighting
• Excessive dust sources such as a workshop or garage
• Excessive moisture
• Extremely low temperature
• Mechanical vibration or shock such as on top of a washing machine or work
bench.
To install the phone:
1. If you plan to place the phone on a flat surface, attach the stand. Line up the
tabs on the stand with the slots on the rear of the phone. Two sets of slots
allow you to attach the stand at either a 45-degree or 35-degree angle. To
wall mount the phone, see the VSP725 Deskset User Guide.
2. Plug the end of the coiled handset cord into the Handset jack on the rear of the
phone. Secure the cord by routing it through the slot and underneath the tab.
45°
Handset jack
Slot and tab
businessphones.vtech.com
10
35°
.