ZyXEL Communications P-2024 Series Support Notes page 8

2. TCP/IP Installation
You must first install TCP/IP software on each computer before you can use it for Internet access. If you have
already installed TCP/IP, go to the next section to configure it; otherwise, follow these steps to install the
software:
•
In the Control Panel/Network
•
In the Select Network Component Type
•
In the Select Network Protocol
Network Protocols
3. TCP/IP Configuration
Follow these steps to configure Windows TCP/IP:
•
In the Control Panel/Network
•
In the TCP/IP
Note: Do not assign arbitrary IP address and subnet mask to your computer(s). Otherwise, you will not be able
to access the Internet.
•
Click the WINS
•
Click the Gateway
none listed.
•
Click the DNS Configuration
•
Click OK to save and close the
•
Click OK to close the Network window. You will be prompted to insert your Windows CD or disk.
When the drivers are updated, you will be asked if you want to restart the computer. Make sure
your P-2024 is turned on before clicking Yes. Repeat the above steps for each Windows computer
on your network.
•
Setting up the P-2024
If you have a Single User Account (SUA), follow the procedure to configure the P-2024. You can use a web
browser (such as IE) to access the embedded web server on the P-2024 for device management. Before you can
log into the web management interface, make sure that there is no one logging into the P-2024 through Telnet
or the console port.
1. Accessing the P-2024 Web Management Interface
window, click
window, select
field and click OK.
window, select
Properties window, select
configuration tab and select
tab. Select any installed gateways and click the
tab and select
TCP/IP
All contents copyright (c) 2006 ZyXEL Communications Corporation.
P-2024 Support Notes
Add button.
window, select Protocol
Microsoft
TCP/IP and click Properties.
obtain an IP address
Disable WINS Resolution.
Disable DNS.
properties window
and click Add.
and then select TCP/IP
automatically.
Remove button until there is
from the
8