ZyXEL Communications P-2024 Series Support Notes page 23

Step 4. In the Phone Port Settings field, select which phone port you want to configure and click Advanced
Setup.
Step 5. Set the phone port parameters and click Apply to save the settings and make the changes take effect. If
you want to configure the second phone port, select SIP2 in the SIP Account field and follow steps 1 – 5.
The table below describes the related fields.
Label Description
Use this field to select the phone port that you want to configure.
Phone Port
Settings
Speaking Use this field to set the loudness that the P-2024 uses for the speech signal
Volume that it sends to the peer device. -1 is the quietest and 1 is the loudest.
Listening Use this field to set the loudness that the P-2024 uses for the speech signal
Volume that it receives from the peer device and sends to your phone. -1 is the
quietest and 1 is the loudest.
Outgoing SIP 1 and SIP 2 correspond to the P-2024's SIP accounts. Select whether
you want the phone(s) attached to this phone port to use SIP account 1, 2 or
Call use
both when you make a call. If you select both SIP accounts, the P-2024 will
first try to use SIP account 2 and then SIP account 1 when you make a call.
G.168 Active Select this check box to cancel the echo caused by the sound of your voice
reverberating in the telephone receiver while you talk.
Select this check box to use Voice Activity Detection (VAD) to reduce the
VAD
bandwidth that a call uses. The P-2024 will generate and send comfort noise
Support
when you are not talking.
When you are dialing a telephone number the P-2024 waits this long after
you stop pressing the buttons before initiating the call. Select how many
Dialing
seconds you want the P-2024 to wait after the last input on the telephone's
Interval
keypad before dialing (making) a call.
Apply Click Apply to save your changes back to the P-2024.
Reset Click Reset to begin configuring this screen afresh.
All contents copyright (c) 2006 ZyXEL Communications Corporation.
P-2024 Support Notes
23