Vehicle Belt Using Base - DJG First Ride Instruction Manual

4358-3394G Designer USA 10/23/06
Rear-Facing Installation with
Vehicle Belt - Using the Base:
1
WARNING:
!
A loose LATCH system can result in
serious injury or death.
2
3
28
4:16 PM Page 31
When LATCH is not
available, fasten belt hooks
together in front of base
as shown.
Place base in the back seat
with taller side against the
back of vehicle seat.
Thread the vehicle lap or
lap/shoulder belt
combination through belt
path as shown. Buckle
vehicle belt.
Push down firmly on the
4
base and pull up on the
belt to tighten. For a
manual belt, refer to
"Knowing Your Vehicle
Belts" section. Pull up on
shoulder strap to
remove any slack.
With weakest hand at belt
5
path, tilt and push the base
forward and back, and
from side to side. If the
seat belts do not loosen,
your child restraint should
be secure.
NOTE:
front to back or about an
inch from side to side is
acceptable. If it moves more, review "Knowing Your
Vehicle Belts" and "The Locking Clip" sections.
WARNING
!
Using this child restraint in any vehicle
seat where the lap belt cannot be
tightened securely and properly or where
it can be loosened by pulling on it can
result in serious injury or death.
With child secured in
6
child restraint, attach to
base. Align notches in
the front of shell with
the bars on the base.
Push down firmly to lock
into place. You will hear
a "click" when it is
locked. Pull up to make
sure it is locked into
place.
29
Some "play" from
continued on next page.