Table of Contents
Advertisement
4358-3394G Designer USA
10/23/06
4
5
NOTE:
Some "play" from front to back or about an
inch from side to side is acceptable. If it moves more,
review "Knowing Your Vehicle Belts" and "The Locking
Clip" sections.
WARNING
!
Using this child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it can result in
serious injury or death.
32
4:16 PM
Page 35
If your shoulder belt is long
enough, you may secure it
behind the seat shell by
threading through both
slots on back of shell.
With weakest hand at belt
path, tilt and push the
child restraint forward
and back, and from side to
side. If the seat belts do
not loosen, your child
restraint should be
secure.
Rear-Facing Installation with
LATCH and Base
NOTE:
Do not use the LATCH system when using
the vehicle lap or lap/shoulder belt.
LATCH is only equipped on the base. If desired, a
LATCH kit or an additional base can be purchased for
use on this child restraint. See replacement parts list.
Place base in the back
1
seat with taller side
against the back of
vehicle seat.
Thread the LATCH belt
2
through belt path as
shown.
NOTE:
adjuster can be on
either side, but belt
should not be twisted.
Fasten one LATCH belt
3
hook to the anchor in
the vehicle seat located
in the vehicle seat bight.
Repeat for other side of
child restraint. See your
vehicle owner's manual
for more information.
33
LATCH
continued on next page.
Advertisement
Table of Contents
