Basic.operation - Panasonic WV-CP630/G Operating Instructions Manual

Basic operation
The operations in the setup menu are performed with the operation buttons after calling up the setup menu on the connected video
monitor.
The description below explains how to operate the setup menu basically.
Screenshots of WV-CP630/G are shown as an example.
Screenshot 1
Hold down the [SET] button for about 2 seconds to call up the
top screen of the setup menu.
MODEL WV-CP630 SERIES
CAMERA ID
CAMERA
SYSTEM
BACK-FOCUS
SPECIAL
LANGUAGE
END SETUP DISABIE
Screenshot 2
The setup mode changes to "ENABLE", and the setup menu
becomes ready to be set.
MODEL WV-CP630 SERIES
CAMERA ID
CAMERA
SYSTEM
BACK-FOCUS
SPECIAL
LANGUAGE
END SETUP ENABLE
Screenshot 3
The selected setup screen in the setup menu appears on the
screen.
**CAMERA SETUP**
SCENE1
ALC/ELC
SHUTTER
AGC
SENS UP
WHITE BAL
DNR
D&N(IR)
VMD
RET TOP END
Note:
• If the top screen of the setup menu is called up with the
operation buttons while the camera is operated, the setup
mode is always "DISABLE" to prevent operation errors.
To perform settings in the setup menu, change the setup
mode to "ENABLE".
• The cursor is a reversely highlighted part.
OFF
OFF
ALC
OFF
ON(HIGH)
OFF
ATW1
HIGH
AUTO1
OFF
Step 1
Press the [UP] or [DOWN] button to move the cursor to "END".
Step 2
Press the [RIGHT] button to move the cursor to "SETUP",
and press the [SET] button to change the setup mode from
"DISABLE" to "ENABLE".
Step 3
Move the cursor to the item to be set, and press the [SET]
button.
Step 4
Perform the settings for each item.
• Selection of setting item:
Press the [UP] or [DOWN] button to move the cursor.
• Change of settings:
Press the [RIGHT] or [LEFT] button.
• Display of advanced setup screen:
Press the [SET] button when " " is attached to the target
setting item.
• Return to previous setup screen:
Move the cursor to "RET" and press the [SET] button.
• Return to the top screen:
Move the cursor to "TOP" and press the [SET] button, to
display the top screen of the setup menu.
Step 5
Move the cursor to "END" and press the [SET] button to return
to the camera image screen, or wait about 5 minutes and the
setup menu will automatically close.
5