Pixel.compensation.[Pix.off]; Communication.setting.[Communication]; Default.resetting.[Camera.reset]; Serial.number.viewing.[Ser.no.] - Panasonic WV-CP630/G Operating Instructions Manual

21. Pixel compensation [PIX OFF]
Flaws of pixel in the displayed camera image are corrected. Up to 16 points can be corrected.
Follow the procedure below.
"SPECIAL SETUP" screen
**SPECIAL SETUP**
....I..160
CHROMA GAIN
..I.... 20
AP GAIN
.I..... 32
PEDESTAL
- +
DISPLAY ALARM
PIX OFF
COMMUNICATION COAX
CAMERA RESET PUSH SET
SER.NO. XXXXXXXX
RET TOP END
Step 1
Move the cursor to "PIX OFF" and press the [SET] button.
→ The "PIX OFF" screen appears.
Step 2
Select a number (1 to 16) with which a pixel compensation point is registered and press the [SET] button.
→ The pixel compensation positioning screen appears.
Step 3
Press the [UP], [DOWN], [RIGHT] and [LEFT] buttons to move the crosshair cursor to the center of the flaw to be corrected and press
the [SET] button.
→ The flaw is corrected and the pixel compensation point is registered. The "PIX OFF" screen appears again. An asterisk "*" is
attached at the right side of the number when registration is completed. The coordinate is expressed in figures.
Note:
• To clear the registered pixel compensation point, move the cursor to "1" of the right of "DEL", use the [RIGHT] and [LEFT] buttons
to select the number with which the target pixel compensation point is registered and press the [SET] button. The registered pixel
compensation point is cleared, and an asterisk "*" at the right side of the number disappears.
22. Communication setting [COMMUNICATION]
The required communication configuration is performed to use this unit integrated into the system with a receiver.
COAX (RCV): When using our receiver (e.g. WV-RC150).
COAX (default): When not using any receiver.
23. Default resetting [CAMERA RESET]
The settings in the setup menu are restored to the default settings.
The default settings are restored by moving the cursor to "PUSH SET" of "CAMERA RESET" and holding down the [RIGHT], [LEFT] and [SET]
buttons for more than 2 seconds simultaneously.
Note:
• The data of the back focus setting and registered pixel compensation points is not cleared.
24. Serial number viewing [SER.NO.]
Displays the serial number of this product.
"PIX OFF" screen
** PIX OFF **
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
000 000
DEL
1
RET TOP END
Pixel compensation positioning screen
25