Panasonic WV-CP630/G Operating Instructions Manual page 16

Step 1
Move the cursor to "MOTION DET" and press the [SET] button.
→ The "MOTION DET" screen appears.
Step 2
Move the cursor to "MASK SET" and press the [SET] button.
→ The mask setting screen appears.
"MOTION DET" screen
** MOTION DET **(1)
.... I .. 20
LEVEL
- +
DWELL TIME 2S
DISPLAY MODE
ALARM OFF
MASK SET
RET TOP END
In the masked area, no alarm will be issued even if a moving object is detected. The masked area is set in the same way as the
masked area setting in "Light quantity control method selection". (
Step 3
Hold down the [SET] button for more than 2 seconds after completion of masking.
→ Return to the previous menu.
Step 4
Move the cursor to "ALARM" and press the [RIGHT] and [LEFT] buttons to select "ON" or "OFF".
ON: Outputs alarm signal when in display mode. Actions may be confirmed through the motion detection mode when a moving
object is detected.
OFF (default): Does not output alarm signal when in display mode.
Step 5
Move the cursor to "DISPLAY MODE" and press the [SET] button.
→ The display mode screen appears.
If a moving object is detected in the set area, the area will be reversely highlighted. Hold down the [SET] button for more than 2
seconds to return.
"MOTION DET" screen
** MOTION DET **(1)
.... I .. 20
LEVEL
- +
DWELL TIME
2S
DISPLAY MODE
ALARM OFF
MASK SET
RET TOP END
Step 6
Move the cursor to "LEVEL" and press the [RIGHT] or [LEFT] button to adjust the level.
Repeat step 5 and 6 to adjust to optimal level.
16
Mask setting screen
☞
page 8)
Display mode screen