Table of Contents
Advertisement
P38DF* Indoor Gas Fireplace
Section 9: Installing the Accessories
Installing the Firestones
The P38DF* is supplied with firestones. Remove the
Door as shown in the previous Instruction. Follow these
instructions to ensure all parts are removed or replaced
as required. Once the Trim and glass door is removed
place the firestones randomly across the pan and the
burners as described in Figure 25 to 25f.
Note: Only cover the burner with one layer of designer firestones.
Figure 25. Up-lighting glass in package.
Figure 25a Place the up-lighting glass in the burner tray.
Figure 25b Installation of the firestones. (Ensure ONLY one
layer of firestones cover the surface).
Figure 25c. Spreading the firestones evenly and make sure
there are no firestones covering the pilot .
Page 24
Installation
Figure 25d. Completed firestone installation.
Figure 25e. Completed firestone installation. (Note: DO NOT
place ANY firestones on top of the pilot cover).
Figure 25f. Gas fireplace with firestones surrounding burner
tray.
If the firestones are not placed properly (ONE LAYER ONLY),
on burners excessive sooting will result. The firestones will
get very hot while the fireplace is in operation, and should
not be handled until cool.
If the pilot cover is covered with firestones it may result in
delayed ignition and/or damage to the appliance and/or
surrounding property.
CAUTION!
WARNING!
XG0193 - 150204.1
Advertisement
Table of Contents
