Advanced Setting/Multicast Paging - Grandstream Networks GXV3275 Administration Manual

Default Ring Cadence
ADVANCED SETTINGS/MULTICAST PAGING
Paging Barge
Paging Priority Active
Multicast Paging Codec
Enable Multicast Paging
Video
Multicast Paging Video Codec
Multicast Paging Image Size
Multicast Paging Video Bit
Rate
Multicast Paging Video Frame
Rate
Multicast Paging H.264 Profile
Type
Multicast Paging H.264
Payload Type
Multicast Listening Address
Firmware Version 1.0.3.46
"Medium" or "High". The default setting is "Low".
It is used to define the ring cadence for the phone. The default setting
is: c=2000/4000.
It is used to set the threshold of paging calls. If the paging call's priority
is higher than the threshold, the existing call will be hold and the paging
call will be answered. Otherwise, the existing call does not be affected.
If it is set to Disable, any paging call will not be answered. The default
setting is "Disable".
It is used to determine if a new paging call whose priority is higher than
the existing paging call will be answered. If it is checked, this feature
will be enabled. The default setting is disabled.
It is used to select the codec type for the multicast paging call. This list
includes PCMU, PCMA, G726-32, G722, and G729A/B.
It is used to enable the video feature to establish a multicast paging
call. The default setting is disabled.
It is used to set the video codec for the multicast paging call. The
default setting is "H.264".
It is used to set the video image size for the multicast paging call. This
list includes 720P, 4CIF, VGA, CIF, QVGA, and QCIF.
It is used to set the video bit rate for the multicast paging call. The
default setting is "256 kbps".
It is used to set the video frame rate for the multicast paging call. This
list includes "15 frames/second",
frames/second", and "Variable frames rate".
It is used to set the H.264 codec profile type for the multicast paging
call. This list includes "Baseline Profile", "Main Profile", and "High
Profile".
It is used to set the H.264 codec payload type for the multicast paging
call. The default setting is "99".
It is used to configure the IP address and port number for monitoring
multicast paging call. When the initiator initiates a call, answer the call
and display listening address and tag of the monitoring target. This
feature supports Video Multicast, when the initiator initiates Video
Multicast, it will automatically add the number 2 on the port of the
listening address. Reboot the phone to make changes take effect. The
GXV3275 Administration Guide
"25 frames/second",
Page 76 of 117
"30