IBM Enterprise Storage Server 2105 E10 Introduction And Planning Manual page 76

IBM recommends that you install the ESS on a raised floor. When you install the
ESS, you can cut out tiles for cable entry at the front. IBM recommends that you
place two fully perforated tiles in front of the ESS for cooling.
Center all openings and cutouts at the front of the enclosures. See Table 12 for the
dimensions for the cutouts. See Figure 9 on page 53 for the cutout locations, and
the clearances that are required for the doors. The ESS has recessed casters that
do not require extra clearance.
52
ESS Introduction and Planning
Table 11. ESS dimensions and weights (continued)
Model Dimensions, Meters
(Inches) (See Note 1.)
Notes:
1. These dimensions include casters and covers. (The casters are recessed and do not
require extra clearance.)
2. These dimensions exclude the top cover. With the top cover, the height is 1.915 m (75.3
in.).
3. Models E10 and F10 do not support the expansion enclosure.
4. Models E20 and F20 and the expansion enclosure are shipped in separate crates. With
the Arbo Crate, the expansion enclosure weighs 1500 kg (3305 lbs).
5. Install the expansion enclosure to the right (as you face its front) of Models E20 and
F20.
6. Install the Model 100 to the right (as you face its front) of Models E10/E20 and E10/F20.
Table 12. Cable cutout dimensions (maximum size)
Model
E10, F10, E20, and F20
Expansion enclosure
100
Dimensions with Arbo
Crate, Meters (Inches)
Floor Cutouts, Meters (Inches)
0.10 x 0.91 (4 x 36)
0.10 x 0.25 (4 x 10)
Front: 0.15 x 0.15 (6 x 6)
Rear: 0.15 x 0.15 (6 x 6)
Maximum Maximum
Weight Weight with
(Fully Arbo Crate
Configured)