Manually Configuring Telephone Connectivity - 3Com 3101 Manual

48 C A: T
HAPTER ELEPHONE
Manually Configuring
Telephone
Connectivity
I M
NSTALLATION AND AINTENANCE
To configure the IP configuration settings manually on your telephone,
use the Program button (see
Configuration menu (menu option 6).
If your telephone received its IP configuration automatically, follow steps
1 through 3 to set the IP address of the 3Com Asterisk Appliance and
your user settings. If your telephone did not receive its IP configuration
automatically from a DHCP server, follow all the steps.
1 Press Program + 5 (Advanced Settings) + 1 to select Set Primary PBX IP.
Use the keypad to set the IP address of the 3Com Asterisk Appliance.
2 Press Program + 5 (Advanced Settings) + 2 to select Set Secondary PBX
IP. Use the keypad to set the IP address of the telephone download
program server, which is the same as the IP address of the 3Com Asterisk
Appliance.
3 Press Program + 5 (Advanced Settings) + 4 to select Set My Phone
Number. Use the keypad to specify the telephone extension. Your
administrator must also configure the extension on the 3Com Asterisk
Appliance.
4 Press Program + 6 (User Configuration) + 2 to select Configure IP
Address. Use the keypad to set the IP address for the telephone, and then
press the # key to save your changes. Note that you can press the
Program button to back out of a menu choice.
5 Press Program + 6 (User Configuration) + 3 to select Configure
SubNetMask and set your network's subnet mask. Note that you can
press the Program button to back out of a menu choice.
6 Press Program + 6 (User Configuration) + 4 to select Configure Gateway
IP Address and set your telephone's default gateway address. Note that
you can press the Program button to back out of a menu choice.
7 Press Program + 6 (User Configuration) + 5 to select Configure NCP IP
Address and set the 3Com Asterisk Appliance IP address. Note that you
can press the Program button to back out of a menu choice.
8 When you are finished, press the Program button to exit from the
configuration menu.
After you manually configure a telephone, the settings are saved in flash
memory and retained when you disconnect power from the telephone.
Buttons and Controls) to enter the User