Cub Cadet 190-341-100 Operator's Manual page 9

CABLE TIE
TILT HANDLE
CABLES
Figure 4-5
6. Route the tilt handle cables along the bend in the lower
end of the chute crank support tube and secure to the
support tube with a cable tie (11, Fig. 3-2). See Figure 4-6.
CHUTE CRANK
SUPPORT TUBE
CABLE TIES
TILT
HANDLE
CABLES
Figure 4-6
7. Route the tilt handle cables across the top of the snow
thrower lift shaft toward the right side of the snow thrower.
Loosely fasten the cables to the lift shaft with a cable tie
(11, Fig. 3-2). Do not fully tighten the cable tie. Refer to
Figure 4-6.
8. Insert the lower end of the lift handle assembly (C, Fig.1)
into the lift bracket located on the right side of the snow
thrower subframe. See Figure 4-7.
RELEASE
HANDLE
HEX FLANGE
LOCK NUT
CHUTE CRANK
SUPPORT TUBE
NOTE: The latch release cable may, or may not, have been
connected to the lift index rod at the factory. If already
connected, skip to Step 12. If not connected, perform the
following steps 9-11 to connect the cable.
9. Insert the bottom of the cable 'Z' end fitting through the
hole in the lift index rod. Refer to Figure 4-6.
10. If necessary, turn the jam nuts on the conduit fitting to
create a space between the nuts. With a jam nut positioned
both above and below the lift bracket, slide the conduit
fitting fully into the slot of the lift bracket. Refer to Fig. 4-6.
11. Temporarily tighten the jam nuts against the upper and
lower surfaces of the lift bracket.
LIFT SHAFT
12. Align the holes of the lift handle and lift bracket, and
secure with the two hex cap screws (6, Fig.2) and hex
flange lock nuts (13, Fig.2). Refer to Figure 4-6.
13. Refer to Lift Latch Adjustment on Page 14 for instructions
to adjust the cable.
14. Route the latch release cable along the lift handle and
secure the cable to the handle using two tie straps (11,
Fig.3-2) as shown in Figure 4-8. Cut the excess from the tie
strap ends.
LATCH
CABLE
LIFT
LIFT INDEX
ROD HOLE
Figure 4-7
CABLE
TIE
Figure 4-8
s
ectiOn
LIFT BRKT.
SLOT
HEX CAP
SCREW
JAM NUT
CONDUIT
FITTING
CABLE 'Z'
END FITTING
LIFT BRACKET
LATCH
RELEASE
CABLE
LIFT HANDLE
TRIGGER
ASSEMBLY
4 — a & s -u
sseMbly et p
9