Cub Cadet 190-341-100 Operator's Manual page 13

5. While manipulating the lift handle to keep the channel
brackets parallel to the tractor frame, lift upward on
the front lift shaft and slide the snow thrower assembly
rearward until the channel brackets are fully inserted into
the frame channels. Secure the assembly to both sides of
the frame using the hex cap screws (9, Fig. 3-2) and bell
washers (15, Fig. 3-2). See Figure 5-4.
CHANNEL BRACKETS
FULLY INSERTED
HEX CAP
SCREW
Figure 5-4
6. Tractors with 15" front tires ONLY.
mounting bracket with the subframe arms and reinstall the
front hex cap screws and flange lock nuts. Tighten the rear
fasteners. See Figure 5-5.
GEARBOX
MOUNTING
BRACKEY
TIGHTEN REAR
FASTENERS
Figure 5-5
IMPORTANT:
Series 2500 Tractors Mfg. Date K015 and After.
To open the tractor hood, the snow thrower must be lowered to the
ground and the discharge chute rotated to the straight forward
position.
7. Raise the tractor hood. Refer to the tractor Operator's
Manual.
BELL WASHER
Align the gearbox
SUBFRAME ARM
REINSTALL
FRONT FASTENERS
NOTE: Use the 754-0441 (D, Fig. 3-1) PTO belt for single
cylinder engines ONLY. Use the 754-3075 (E , Fig. 3-1) belt
for twin cylinder engines ONLY.
8. Install the appropriate PTO belt (D or E) on the PTO clutch
pulley on the front of the engine by passing the belt
upward inside the front of the tractor frame. Make certain
the narrow side of the PTO belt engages the groove of the
clutch pulley. See Figure 5-6.
FRONT IDLER PULLEYS
Figure 5-6
9. Twist the PTO belt 1/4 turn inward to engage the narrow
sides of the belt in the grooves of the tractor's two front
idler pulleys. Refer to Figure 5-6.
10. Routing the PTO belt rearward under the tractor frame,
install the narrow side of the belt in the V-pulley on the
snow thrower gearbox. See Figure 5-7. Make certain there is
no more than a 1/4 inward twist in both runs of the belt.
V-PULLEY
Figure 5-7
s
ectiOn
PTO CLUTCH
PTO BELT
PTO BELT
5— i & r
nstallatiOn eMOval
13