Cub Cadet 190-341-100 Operator's Manual page 19

Off-Season Storage
At the end of the snow season the following steps are
recommended:
1. Remove the snow thrower assembly from the tractor.
2. Wash off any salt deposits which may have dried on the
snow thrower housing. Paint, or cover with a light coat of
oil, any exposed metal surfaces.
3. Lubricate bearings and pivot points with a good grade of
spray lubricant.
4. Store the snow thrower in a dry place.
Additional Accessory Requirements
Weight Kit Model 307
WARNING!
The weight kit, Model 307, must be
installed on the rear of the tractor whenever the
snow thrower attachment is installed on the front of
the tractor. The weight kit must be used with the
proper weights.
1. At all times that the snow thrower is installed on the front
of the tractor, the weight kit must be installed on the rear
of the tractor. The weight kit counterbalances the weight of
the snow thrower and provides stability to the tractor.
2. Depending upon the prevailing conditions, a minimum
of two suitcase weights and a maximum of four suitcase
weights must be used with the weight kit.
3. Refer to the weight kit Operator's Manual for detailed
instructions pertaining to the proper installation of the
weight kit onto the rear of the tractor.
Tire Chains
Tire chains are recommended when using the 42-inch snow
thrower attachment. Tire chains are available at your authorized
Cub Cadet dealer.
s 7— M
ectiOn aintenance
19