Dell PowerEdge M830 Owner's Manual page 38

1. Ensure that you read the
2. If installed, remove the front bezel from the PowerEdge VRTX enclosure.
3. Turn off the server module using the operating system commands or the CMC, and ensure that the
server module is powered off.
When a server module is powered off, its front-panel power indicator is off.
Steps
1. Press the release button on the server module handle.
2. Pull the server module handle to unlock the server module from the enclosure.
CAUTION: If you are permanently removing the server module, install a server module
blank(s). Operating the system for extended periods of time without a server module blank
installed can cause the enclosure to overheat.
3. Slide the server module out of the enclosure.
CAUTION: To prevent damage to the I/O connectors, do not touch connectors or the
connector pins.
CAUTION: To protect the I/O connector pins, install the I/O connector covers every time a
server module is removed from the enclosure.
4. Install the I/O connector cover over the I/O connector.
Figure 5. Removing and installing a server module
1. release button
3. server module
Related Links
Installing a server module
38
Safety instructions.
2. VRTX enclosure