Q-See QT Series User Manual page 16

Changing Display Resolution
You can adjust the DVR to optimize its output
to best match the capabilities of your monitor
or HD display through the following steps:
STEP 1. Open the Basic window in the
Setup window which is located in the
Main Menu.
STEP 2. Click on the System tab.
STEP 3. Use the Video Output pull-down to
select your desired resolution.
STEP 4. Click on Apply to save your settings
and then click Exit.
STEP 5. Your system will restart. You will
have to re-log in afterwards.
Television
A third option for a video display is any television with an RCA video input. The DVR's Video
Out port uses a BNC (British Naval Connector) type for coaxial cable. Depending on model,
your DVR may include a BNC-to-RCA cable or adapter. The latter converts the BNC jack to
an RCA port allowing you to connect the DVR to the television using a readily available RCA
cable. If you use a television as your video display, you will need to switch the DVR to use that
as a primary output by following Step 4, below:
STEP 1. Connect a BNC-to-RCA cable to the "Video Out" port on the back of the DVR.
STEP 2. Plug the RCA end into the "Video In" port on the television.
STEP 3. Plug the television's power cable into a surge protector.
STEP 4. Press and hold the STOP, STOP/ESC, EXIT, n/ESC or VGA/TV (depending on model)
button on the front of the DVR for 10 seconds or until you hear a beep to indicate that the video
mode has been changed.
16
BASIC BASIC
System System Date & Time Date & Time
Device Name Device Name
Device ID Device ID
Video Format Video Format
Password Check Password Check
Show System Time Show System Time
Max Online Users Max Online Users
Video Output Video Output
Language Language
Logout After [Minutes] Logout After [Minutes]
Startup Wizard Startup Wizard
No Image When Logout No Image When Logout
PICTURE 2-9
DST DST
EDVR EDVR
0 0
NTSC NTSC
10 10
HDMI HDMI
English English
5 5
Default Default Apply Apply
PICTURE 2-8
Exit Exit