Bench Mounting - King Canada 8370 Instruction Manual

SELF-RETRACTING ROTATING BLADE GUARD
The rotating blade guard (A) Fig.7 provides protection from both sides of the
blade. It retracts over the upper blade guard (B) as the saw is lowered into the
workpiece.
DUST BAG
The dust bag fits over the dust bag adaptor at the rear of the saw head. For
more efficient operation, empty the dust bag when it is no more than half full.
This allows better air flow through the bag.
DEPTH OF CUT STOP ADJUSTMENT
In its normal position, the depth of cut stop Fig.8 permits the saw blade to cut
right through a workpiece.
When the saw arm is lifted, the depth of cut stop (A) Fig.9 can be pulled out so
that the depth adjustment screw (B) contacts the stop as the saw arm is
lowered. This resricts the cut to a "adjusted depth" in the workpiece. The depth
of cut can be adjusted with the adjustment screw and locked in position with
the lock nut (C).

BENCH MOUNTING

The saw base has holes to facilitate bench mounting.
1. Fix the saw to the bench using 4 hex. bolts and hex. nuts.
2. If desired, you can mount the saw to a piece of 13mm or thicker plywood
which can then be clamped to your work support or moved to other job sites
and reclamped.
CAUTION: Make sure that the mounting surface is not warped as an uneven
surface can cause binding and inaccurate sawing.
ADJUSTMENTS & OPERATIONS
B
Figure 7
Figure 8
Figure 9
A
B
C
A