Please keep your dated proof of purchase for warranty and servicing purposes. REPLACEMENT PARTS Replacement parts for this product are available at our authorized King Canada service centers across Canada. Please use the 10 digit part numbers listed in this manual for all part orders where applicable.
GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS VOLTAGE WARNING: Before connecting the tool to a power source (receptacle, outlet, etc.) be sure the voltage supplied is the same as that specified on the nameplate of the tool. A power source with voltage greater than that for the specified tool can result in SERIOUS INJURY to the user - as well as damage to the tool.
Page 4
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR COMPOUND MITER SAW 1. WARNING: USE ONLY CROSS-CUTTING SAW BLADES. 18. NEVER reach around or behind saw blade. WHEN USING CARBIDE TIPPED BLADES, DO NOT USE BLADES WITH DEEP GUILLETS AS THEY CAN DEFLECT 19. MAKE SURE blade is not contacting workpiece before switch is AND CONTACT GUARD.
For circuits that are further away from the electrical circuit box, the wire size must be increased proportionately in order to deliver ample voltage to the Miter Saw motor. Refer to Fig.2 for wire length and size. SPECIFICATIONS Model ......................................8324NS Voltage ....................................110V-120V Input power ....................................15 Amp. No load speed ..................................4,800 RPM Blade size..................................10”...
Page 6
ASSEMBLY UNPACKING Due to modern mass production techniques, it is unlikely that your King Canada power tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified.
OPERATING CONTROLS STARTING AND STOPPING SAW To turn the saw "ON" press in the safety button (A) Fig.7 and then pull the large trigger switch (B). To turn the saw "OFF" release trigger switch. LOCKING CUTTING ARM IN THE DOWN POSITION FIGURE 7 When transporting the miter saw, the cutting arm should always be locked in the down position.
Page 8
ADJUSTMENTS ADJUSTING FENCE 90 DEGREES TO BLADE 1. DISCONNECT THE SAW FROM THE POWER SOURCE. 2. Place the cutting arm in the 90 degree straight cut-off position, as shown in Fig.11A, and tighten the table lock knob. 3. Using a square (A) Fig.11A, place one end of the square against the blade and the other end against the fence, as shown.
Page 9
ADJUSTMENTS & CHANGING BLADE LASER GUIDE SYSTEM Your compound miter saw comes equipped with a laser guide system which allows quick and accurate set-ups and cuts. This laser guide system is battery powered, therefore we suggest that the laser guide be turned off while not in use to save battery life.
Page 10
If a brush needs replacement, replace both brushes. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list. FIGURE 21...