Warning! Ic Rss General Requirements - Vertex Standard VX-820 Series Operation Manual

e
nglish
r Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interfer-
ence to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary for successful communication.
r This radio transmitter (identify the device by certification number, or model number if Category II) has been
approved by Industry Canada to operate with the antenna types listed at the right with the maximum permis-
sible gain and required antenna impedance for each antenna
type indicated. Antenna types not included in this list, having
a gain greater than the maximum gain indicated for that type,
are strictly prohibited for use with this device.
¦ When transmitting, hold the radio in a vertical position with its microphone 2 inches (5 cm) away from
your mouth and keep the antenna at least 2 inches (5 cm) away from your head and body.
¦ The radio must be used with a maximum operating duty cycle not exceeding 50%, in typical Push-to-
Talk configurations.
DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than
50% of the time can cause IC RSS General Requirement to be exceeded. To keep the Body Worn con-
figuration with the Vertex Standard CLIP-820 belt-clip, reduce the maximum operating duty cycle still
more.
The radio is transmitting when the red LED on the top of the radio is illuminated. You can cause the
radio to transmit by pressing the P-T-T button.
¦ SAR compliance for body-worn use was only demonstrated for the specific belt-clip (CLIP-820). Other
body-worn accessories or configurations may NOT comply with the IC RSS General Requirement and
should be avoided.
¦ When operate the radio with the Vertex Standard CLIP-820 belt-clip, make the transmission time as
short as possible, to keep the Body Worn configuration.
6
W ! iC rss g
arning
r
eneral equirement
Vhf m
odel
ATV-8A: 2.15 dBi, 50-ohm
ATV-8B: 2.15 dBi, 50-ohm
ATV-8C: 2.15 dBi, 50-ohm
VX-820 S
uhf m
odel
ATU-6A1: 2.15 dBi, 50-ohm
ATU-6D: 2.15 dBi, 50-ohm
ATU-6F: 2.15 dBi, 50-ohm
O M
erieS perating anual