Integrated Peripherals - ECS B75H2-AM2 User Manual

36

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
Main
Onboard SATA Controller
Onboard SATA Mode
Onboard USB Controller
Legacy USB Support
USB Storage Emulation
Onboard Graphics Controller
Onboard Audio Controller
Onboard LAN Controller
Onboard LAN Option ROM
Serial Port1 Address
Serial Port2 Address
Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
Onboard SATA Controller (Enabled)
This item allows you to enable or disable the onboard SATA controller.
Onboard SATA Mode (Native IDE)
Use this item to select the mode of the Serial ATA.
Onboard USB Controller (Enabled)
Use this item to enable or disable the onboard USB controller. We recommend users
keep the default value.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Disabling it might
cause the USB devices not to work properly.
USB Storage Emulation (Auto)
If Auto, USB device equal or less than 2GB will be emulated as Floppy and remaining
as hard drive. Forced FDD option can be used to force a HDD formatted drive to boot
as FDD (Ex. ZIP drive).
Onboard Graphics Controller (Enabled)
This item indicates the status of the onboard graphics controller.
Onboard Audio Controller (Enabled)
This item enables or disables the onboard audio controller.
Onboard LAN Controller (Enabled)
This option allows you to control the onboard LAN device.
Onboard LAN Option ROM (Disabled)
This item enables or disables the onboard LAN option ROM function.
Serial Port1 Address (3F8, IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
Advanced Power Security
[Enabled]
[Native IDE]
[Enabled]
[Enabled]
[Auto]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[3F8,IRQ4]
[2F8,IRQ3]
[378]
[Normal]
[IRQ7]
Version 2.14.1219. Copyright (C) 2002-2012, Acer Inc.
BIOS Setup Utility
Boot Options
Using BIOS
Exit
Onboard SATA Controller.
:Move
Enter : Select
+/-/Spacebar : Change Opt.
F7: Load User default Settings
F8: Save as User Default
Settings
F9: Load Default Settings
F10: Save & Exit Setup
ESC: Discard changes and Exit
Setup