Power Menu - ECS B75H2-AM2 User Manual

Power Menu

This page sets up some parameters for system power management operation.
Main Advanced
ACPI Aware O/S
ACPI Suspend Mode
Deep Power off Mode
Power on by RTC Alarm
Power on by PCIE Devices
Power on by PCI Devices
Power on by Modem Ring
Power on by Onboard LAN
Wake up by USB KB/Mouse
Restore On AC Power Loss
ACPI Adware O/S (Yes)
This item supports ACPI (Advanced Configuration and Power Management
Interface). Use this item to enable ACPI feature.
ACPI Suspend Mode [S3(STR)]
Use this item to define how your system suspends. In the default, S3(STR), the
suspend mode is suspend to RAM, i.e., the system shuts down with the exception of
a refresh current to the system memory.
Deep Power off Mode (Disabled)
This item allows users to enable or disable the Deep Power off Mode.
Power on by RTC Alarm (Disabled)
This system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system RTC (realtime
clock). Use the items below this one to set the date and time of the wake-up alarm.
You must use an ATX power supply in order to use this feature.
Power on by PCIE Devices (Enabled)
This system can be turned off with a software command. If you enable this item, the
system can automatically resume if there is an incoming call on the PCIE LAN card.
You must use an ATX power supply in order to use this feature. Use this item to do
wake-up action if inserting the PCIE card.
Power on by PCI Devices (Enabled)
This system can be turned off with a software command. If you enable this item,
the system can automatically resume if there is an incoming call through the PCI
device connected. You must use an ATX power supply in order to use this feature.
Use this item to do wake-up action if inserting the PCI device.
BIOS Setup Utility
Power Security Boot Options
Version 2.14.1219. Copyright (C) 2002-2012, Acer Inc.
Using BIOS
Exit
Select the highest ACPI sleep
[Yes]
state the system will enter
[S3(STR)]
when the SUSPEND button is
[Disabled]
pressed.
[Disabled]
[Enabled]
:Move
[Enabled]
[Disabled]
Enter : Select
[Enabled]
+/-/Spacebar : Change Opt.
[Enabled]
F7: Load User default Settings
[Off]
F8: Save as User Default
Settings
F9: Load Default Settings
F10: Save & Exit Setup
ESC: Discard changes and Exit
Setup
39