Hdmi; Troubleshooting - Marantz SR7001 User Manual

HDMI

SYMPTOM
The display does not The connected monitor or projector
appear over an HDMI does not support HDCP.
connection.
The HDMI input of on the TV is
not on.
The HDMI output on the source
component (DVD, Set Top Box,
etc.) is not on.
The HDMI mode is not correctly
set on the SR7001/SR8001.
The HDMI output video resolution
of the source component (DVD,
Set Top Box, etc.) does not match
the TV specifi cations.
The device is connected with a
non-standard HDMI cable.
Power to the SR7001/SR8001 is
off. (When the SR7001/SR8001
is on standby, HDMI connections
cannot be turned on.)
T h e c o n n e c t i o n b e t w e e n
HDMI components was not
authenticated.
Time is needed for the T h e c o n n e c t i o n i s b e i n g
d i s p l a y o f a n H D M I authenticated between the HDMI
connection to appear. devices.
Audio is not played The HDMI audio output of the
back over an HDMI source component (DVD, Set
connection. Top Box, etc.) is not on.
The signal format of the source
component (DVD, Set Top Box,
etc.) is not supported by the
SR7001/SR8001.
The SR7001/SR8001 is set to
the HDMI audio "THROUGH"
mode.
DVD-Audio is not played The DVD player does not support
back over an HDMI CPPM, therefore it cannot output
connection. HDMI audio.
68
CAUSE REMEDY
Set HDMI input so that it turns on, as
explained in the TV's instruction manual.
Set HDMI output so that it turns on, as
explained in the source component's
instruction manual.
Set HDMI input on the FUNC INPUT
SETUP menu as explained on page 25.
Set the resolution so that it matches, as
explained in the instruction manuals of both
components.
A 5 m or shorter cable is recommended to
ensure stable operation and prevent image
quality deterioration.
Turn on the power to the SR7001/
SR8001.
Shut off and then turn the power back on
to the SR7001/SR8001, TV and source
component.
There is nothing wrong with the system.
Some HDMI devices require time for
authentication.
Set the HDMI audio output so that it turns
on, as explained in the source component's
instruction manual.
Set the HDMI audio output so that it
can connect to the SR7001/SR8001,
as explained in the source component's
instruction manual.
In the "THROUGH" mode, sound is not
produced from the SR7001/SR8001. Set it
to "ENABLE". (see page 36)
• Use a DVD-Audio player that supports
CPPM.
• Turn on PCM downsampling on the DVD
player.
• Use an analog connection.

TROUBLESHOOTING

If a problem should arise, fi rst check the following.
1. Are the connections correct?
2. Have you operated the receiver according to the operating instructions?
3. Are the speakers and other components operating properIy?
If this unit is not operating properly, Check the items listed in the table beIow. Should the problem persist, there
may be a malfunction. Disconnect the power immediately and contact your store of purchase.
SYMPTOM
"ANTENNA" is displayed. XM terminal and the XM Connect-and-
Play antenna or Passport system is not
properly connected.
"NO SIGNAL" is displayed. The signal cannot be received.
Receiving only XM channels 0 and 1. The XM Tuner is not activated.
CAUSE REMEDY
Check that the connection are correct.
Reposition your XM Connect-and-Play
antenna.
Contact XM Radio.