Setup; Onscreen Display Menu System - Marantz SR7001 User Manual

SETUP

After all components are connected, initial setup
must be performed.

ONSCREEN DISPLAY MENU SYSTEM

The SR7001 incorporates an onscreen menu system,
which makes various operations possible by using
the cursor (3, 4, 1 , 2) and OK/ENTER buttons on
the remote control unit or on the front panel.
Note:
• To view the onscreen displays, make certain you
have connected the MONITOR OUT jack on the rear
panel to the composite, S-Video, component video
or HDMI input of your TV or projector. (See page
15, 16)
1.
Press the AMP button on the remote control
unit. (This step is not needed when operating
the setup menus from the SR7001.)
2.
Press the MENU button on the remote control
or press the MENU button on the front panel.
The "MAIN MENU" of the OSD menu system
is displayed.
There are 6 items in the MAIN MENU.
3. Select the desired sub-menu with the 3 or
4 cursor buttons and press the OK/ENTER
button. The display will change to the selected
sub-menu.
Notes:
• If you desire to adjust any sub-menu, you need to set
it to UNLOCKED.
• To lock sub-menus, set items 1-6 on the MAIN
MENU to "LOCKED".
<LOCKING SUBMENUS>
(1) Move the cursor to "1. INPUT SETUP" in the
MAIN MENU.
(2) Select the "0" mark left of "LOCKED" with the 1
or 2 cursor buttons.
4.
To exit from OSD menu system, press the
EXITbutton, or move the cursor to EXIT and
press the OK/ENTER button.
Note:
• Settings are entered with the ENTER button on the
unit or the OK button on the remote control unit.
When using the remote control unit, use the OK
button as if it were the ENTER button.
22
RC8001SR BUTTON CONTROL
CH
LEFT button
OK button
PREV
MENU
TEST
1
MENU button 7.1CH
4
Press this button to display
the OSD menu system.
SR7001 FRONT BUTTON CONTROL
MULTI
AUTO MULTI SPEAKER
7.1CH INPUT
THX
LEFT button
MENU
MENU button
Press this button to display the
DOWN button
OSD menu system.
UP button
VOL
RIGHT button
OK
DOWN button
LIP·SYNC
MUTE
GUIDE
EXIT
CH.SEL SURR
2 3
ATT SPK-AB EXIT button
5 6
Press this button to exit the OSD
menu system.
UP button
ENTER button
BAND T-MODE MEMORY
DISPLAY
MultEQ
RIGHT button
ENTER
EXIT
MIC
EXIT button
Press this button to exit the
OSD menu system.
AMP (Amplifi er) button
TUNER CD CD-R MD
TAPE AUX1 AUX2 AMP
LIGHT
1 2
RC8500SR
Learning Remote Controller