I-Series Indoor Gas Fireplace
Standard or Oversized Faceplate Installation
The Faceplate Surround has 2 main parts, the rear panel
and the front panel. The Rear Panel has an master override
switch installed on the upper right corner. The Rear Panel
has to be installed first.
Found behind panel
Figure 6 Sec.7 Standard or Oversized Faceplate Kit Contents
Figure 7 Sec.7 The Rear Faceplate Panel
1). Remove the Lighting Instructions from the Control area and
leave on the floor in front of the unit.
Figure 8 Sec.7
Page 26
Installation
2). Make sure that the attachment screw is installed in the small
tab at the lower front right part of the Rear Faceplate and the lower
left corner of the firebox shell.
Screws supplied
Figure 9 Sec.7
Figure 10 Sec.7
3) Lift the Rear Faceplate up and over the Magnets located the
top of the fireplace.
Figure 11 Sec.7
XG00516-060614