Step Record Page - Korg Liverpool Owner's Manual

94 Song operating mode

Step Record page

Resol (Resolution)
Use this parameter to set the quantization during
recording. Quantization is a way of correcting tim-
ing errors; notes played too soon or too later are
moved to the nearest axis of a rhythmic "grid", set
with this parameter, thus playing perfectly in time.
Hi No quantization applied.
(1/32)... (1/8)
Grid resolution, in musical values. For
example, when you select 1/16, all notes
are moved to the nearest 1/16 division.
When you select 1/8, all notes are moved
to the nearest 1/8 division
No quanti-
zation
1/16
1/8
Meter
This is the meter (or time signature) of the Song. You
can edit this parameter only when the Song is empty,
i.e. before you begin recording anything. To insert a
meter change in the middle of the Song, use the "Insert
Measure" function (see page 102).
Sel.Tempo (Select Tempo)
Select this parameter to use the TEMPO/VALUE con-
trols to set the tempo.
Note: You can always change the Tempo, when other param-
eters are selected, by keeping the SHIFT button pressed, and
rotating the DIAL.
Note: The tempo is always record in overwrite mode (old
data is replaced by the new data).
Tempo (Tempo mode)
This parameter sets the way tempo events are read.
Record All Tempo changes made during record-
ing will be recorded to the Master Track.
Auto The Sequencer plays back all recorded
Tempo events. No new Tempo events are
recorded.
Manual The latest manual Tempo setting (made
using the TEMPO/VALUE controls) is
considered the current Tempo value. No
Tempo change will be recorded. This is
very useful to record the Song much
slower than its actual Tempo.
STEP RECORD PAGE
Access this page from the Main page of the Song
Record mode, by selecting the "StepDub" or "Ste-
pOwr" recording mode ("Rec" parameter), and press-
ing SEQ1 PLAY/STOP.
.
(a) section
Previously inserted event. You may delete this event,
and set it in edit again, by pressing the < button.
(b) section
Event to be inserted. See the following parameters for
information on each element of this section.
M (Measure)
This is the position of the event (note, rest or chord) to
be inserted.
Meter
Meter of the current measure. This parameter can't be
edited. You can set a Meter change by using the Insert
function of the Edit menu, and inserting a new series of
measures with a different Meter (see "Page 22 - Edit:
Insert Measures" on page 102).
key?
This is a prompt, asking for a note or chord to be
played on the keyboard, to enter an event on the cur-
rent step.
Step value
Length of the event to be inserted. Use the NOTE
VALUE buttons, on the lower left area of the control
panel, to change this value.
...
Dot (.)
Triplet (3)
V (Velocity)
Set this parameter before entering a note or chord. This
will be the playing strength (i.e., velocity value) of the
event to be inserted.
KBD
Previous event Event to be inserted
(a)
(b)
Current position Step value
Waiting for a keystroke...
Note value.
Augments the selected note by one half of
its value.
Makes the selected note a triplet note.
Keyboard. You can select this parameter,
by turning all counter-clockwise the dial.
When this option is selected, the playing
strength of the played note is recognized
and recorded.