Korg Liverpool Owner's Manual page 20

Table of Contents

Advertisement

18
Front panel
Note: The Master Transpose has no effect on tracks set to
Drum mode (and, even if set in a different status, on the
Drum and Percussion tracks). See "Page 14 - Track: Mode"
on page 46, and "Page 7 - Track: Mode" on page 78.
Lowers the Master Transpose a semitone.
Raises the Master Transpose a semitone.
47 OCTAVE
These buttons transpose the selected track in steps of a
whole octave (12 semitones; max ±2 octaves). The trans-
position value is shown (in octaves) on the top right
area of the display.
Press both buttons together, to reset the Octave Trans-
pose to zero.
Note: The Octave Transpose has no effect on tracks set to
Drum mode (and, even if set in a different status, on the
Drum and Percussion tracks).
Lowers the selected track an octave.
+
Raises the selected track an octave.
48 BALANCE slider
In Song Play mode, this slider balances the volume of
the two on-board sequencers. When fully on the left,
only Sequencer 1 can be heard. When fully on the right,
only Sequencer 2 can be heard. When in the middle,
both sequencers will play at full volume.
49 SEQUENCER TRANSPORT CONTROLS - SEQ1
and SEQ2
The instrument is equipped with two sequencers
(Sequencer 1 and Sequencer 2), each with its own set of
transport controls.
<< and >>
Rewind and Fast Forward commands. If
you use them while the Song is in play,
they make it scroll back or forward.
When pressed once, these buttons move
the Song to the previous or following
measure. When kept pressed, they make
the Song scroll continuously, until you
release them.
In Jukebox mode (Sequencer 1),
keep the SHIFT button pressed, and press
these buttons to scroll to the previous or
next Song in the Jukebox list (see "Page 9 -
Jukebox" on page 79).
PAUSE
Pauses the Song at the current position.
Press PAUSE or PLAY/STOP to start the
Song playing again.
PLAY/STOP Starts or stops the current Song. When
you stop the Song, the Song Position goes
back to measure 1.
In Song Play mode, pressing this
button while keeping SHIFT pressed,
starts both sequencers at the same time.

Advertisement

Table of Contents
loading

Table of Contents