General Information - Jøtul GI 635 DV IPI Installation And Operation Instructions Manual

Hide thumbs Also See for GI 635 DV IPI:
Table of Contents

Advertisement

General Information

THIS HEATER MUST BE INSTALLED AND
MAINTAINED BY A QUALIFIED SERVICE AGENCY.
DO NOT ATTEMPT TO ALTER OR MODIFY
THE CONSTRUCTION OF THIS APPLIANCE
OR ITS COMPONENTS. ANY MODIFICATION
OR ALTERATION WILL VOID THE WARRANTY,
CERTIFICATION AND LISTING OF THIS APPLIANCE.
IMPORTANT: SAVE THESE INSTRUCTIONS.
1. The installation and repair of this appliance must be
done by a qualified service person. Failure to properly
install and maintain this heater could result in an
unsafe or hazardous installation, which may result in
a fire, explosion, property damage, personal injury or
loss of life.
2. This appliance should be inspected before use and
at least annually. More frequent cleaning may be
required due to excessive lint from carpeting, bedding
material, pet hair, dander, etc. It is imperative that
control compartments, burners and circulating air
passageways of the appliance be kept clean.
3. This appliance may be installed in an aftermarket
permanently located, manufactured (mobile) home,
where not prohibited by local codes.
This appliance is only for use with the type(s) of gas
indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certified
kit is used.
4. The installation must conform to local codes. Your
local Jøtul authorized dealer can assist you in
determining what is required in your area for a safe
and legal installation. Some areas require a permit
to install a gas burning appliance. Always consult
your local building inspector or authority having
jurisdiction to determine what regulations apply in
your area.
In the absence of local codes, the installation
requirements must comply with the current National
codes. In the U.S., these requirements are established
in the National Fuel Code, ANSI-Z223.1.(NFPA 54). In
Canada, the codes have been established in CAN/CGA
B149 Fuel Installation Code.
5. Do not operate this fireplace if any part of it has been
under water.
Immediately call a qualified service technician to
inspect the heater and to replace any part of the
control system and any gas control which has been
under water.
6. Do not operate the fireplace with the glass front
removed, cracked, scratched, or broken. Replacement
of the glass should be done by a licensed or qualified
service person. Only remove glass for routine service.
Always handle glass carefully.
7. Notify your insurance company before proceeding with
installation of this fireplace.
Your fireplace insert has a unique serial number
stamped on the rating plate which is located in the
right side compartment. Please record the serial
number in the space below. You may also wish to
attach your purchase receipt to this page for future
reference.
MODEL NAME: Jøtul GI 635 DV IPI Gas Fireplace Insert
SERIAL NUMBER:_______________________________
DATE OF PURCHASE:____________________________
AUTHORIZED DEALER:__________________________
ADDRESS ___________________________________
PHONE: ____________________________________
INSTALLER:__________________________________
FUEL TYPE:____________________________________
FUEL CONVERSION:
NO _______
NOTES:________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
139712_R00 GI 635 IPI Sept. 2015
YES_____
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents