Timer-Recording Radio Programs - Sony MHC-V909AV Operating Instructions Manual

Timer-recording radio
programs
To timer-record, you must preset the radio
station (see "Step 4: Presetting radio
stations") and set the clock (see "Step 3:
Setting the time") beforehand.
7
2
TIMER SELECT
1
Tune in the preset radio station (see
"Listening to the radio").
2
Press CLOCK/TIMER SET.
"SET (DAILY 1)" appears.
3
Turn the jog dial to select REC, then
press ENTER/NEXT.
"ON" appears and the hour indication
flashes in the display.
60
10/57-60_MHC-V909AV.11E
Actual page number:
3,4
6
REC
VOLUME
60
4
Set the time to start recording.
Turn the jog dial to set the hour, then
press ENTER/NEXT.
The minute indication starts flashing.
Turn the jog dial to set the minute, then
press ENTER/NEXT.
The hour indication flashes again.
5
Set the time to stop recording
following the above procedure.
The start time appears, followed by the
stop time, the recording source and the
radio station, then the original display
appears.
6
Insert a recordable tape.
7
Turn off the power.
When the recording starts, the volume
level is set to the minimum.
To check the setting
Press TIMER SELECT and turn the jog dial to
select "REC", then press ENTER/NEXT. To
change the setting, start over from step 1.
To cancel the timer operation
Press TIMER SELECT and turn the jog dial to
select "OFF", then press ENTER/NEXT.
Notes
• When setting the timer-recording, set the equalizer
display to anything other than Spectrum analyzer
pattern 3. (See "To change the equalizer display"
on page 54.)
• If the power is on at the preset time, the recording
will not be made.
98.11.9, 11:49 AM
SONY MHC-V909AV (E) 3-860-316-11
REC
VOLUME