Cleaning Burner And Flue Duct; Clean Inner Tank; Functional Check; Recycling/Disposal 7 - Vaillant atmoSTOR VGH classic 130/6 Z Instructions For Use And Installation

Figure 19 Check magnesium protection anode
6.4 Cleaning burner and flue gas duct
• Close gas shut-off valve
Clean flue duct:
• Remove the draught diverter, take off the flue coil and
clean them
Clean burner:
• Take off the gas section cover, pulling it to the front
• Remove the burner as follows
– Unscrew the gas line screwing 1
– Remove the screw 2
– Move the gas section to the right, remove the support
from the opening 3
– Draw the complete burner unit downwards and then
remove it by pulling it to the front
• Thoroughly clean burner and pilot burner
• Check the thermocouple, electrode and pilot burner
nozzle
• For re-assembly, proceed in reverse order. The burner
groove must be engaged correctly in the burner funnel 2
Figure 20 Remove burner
Figure 21 Remove burner
Gas-fired hot water cylinders atmoSTOR VGH classic
1
Figure 22 Remove burner
6.5 Clean inner tank – of the atmoSTOR
• Rinse the inner tank with water to clean it

6.6 Functional check

• After the inspection check the appliance function and
the safety group
7 Recycling/Disposal

7.1 Appliance

The recycling at a later date and the disposal of Vaillant
products are already considered during the product
development. Strict requirements are laid down in the
Vailland standards. When selecting the materials, account
is taken of the material recyclability, the demountability
and separability of materials and components as well as
environmental hazards and health risks during recycling
and depositing of unavoidable parts of non-recycable
residues.
92% of your Vaillant gas-fired atmoSTOR VGH classic
consist of metallic materials which can be molten again
in steel works and are therefor recyclable for an unlimited
period of time. The used plastics are to be marked so
3
that an assortment and fractioning of the materials is
already prepared for later recycling.
2
1

7.2 Packing

Vaillant has limited the transport packings of the appli-
ances to strict necessities. The selection of the packing
materials involves consistent consideration of a possible
recycling.
For some time, the high-quality cardboard boxes have
been a very demanded secondary raw material in the
cardboard and paper industry. The used EPS (styropore)
is necessary to protect the products during transport.
EPS can be recycled to 100%. Even the foils and tapes
are made of recyclable plastic.
Inspection/Maintenance 6

Recycling/Disposal 7

1 2
GB
13