Troubleshooting Suggestions - Wells OC1 Owner's Manual

TROUBLESHOOTING SUGGESTIONS

CAUTION:
Removal of any cabinet panel will result in exposed electrical circuits.
Any procedure requiring the removal of any cabinet panel must be performed
by a qualified technician only.
CAUTION:
Fuse replacement may expose dangerous voltages.
Fuse replacement must be performed by a qualified technician.
SYMPTOM
No power to appliance
Oven will not heat
Blower fan will not run
Door pops open during cook
cycle
NOTE: There are no user serviceable components in the appliance. In all cases of damage or component malfunction,
ELECTRICAL SHOCK HAzARD
ELECTRICAL SHOCK HAzARD
TROUBLESHOOTING
POSSIBLE CAUSE
Circuit breaker off or tripped
Power cord unplugged or damaged
Fuse blown or loose
Power switch turned to OFF or FAN
Temperature control not set
Oven door not closed
Hi-limit control tripped on excessive oven
temperature
Damaged controller
Fan switch OFF
Damage to internal components
Latch out of adjustment
contact your Authorized Wells Service Agency for repairs.
Reset circuit breaker
Check power cord. Plug in or repair as
required
Check power fuses. If blown, correct
problem and replace fuses
Turn power switch ON
Set to desired temperature
Be sure door is closed and latched
Allow oven to cool, Hi-limit will reset
Contact Authorized Wells
Service Agency for repairs
Turn fan switch to HIGH or LOW
Contact Authorized Wells
Service Agency for repairs
Adjust latch
12
SUGGESTED REMEDY