Preventative Maintenance - Wells OC1 Owner's Manual

PREVENTATIVE MAINTENANCE

CAUTION:
BURN HAZARD
Allow appliance to cool
completely before adjusting.
Hinge Adjustment
HINGE ADJUSTMENT
None
PRECAUTIONS:
Monthly, at a Minimum; or, As Needed
FREQUENCY:
Phillips (+) Screwdriver
TOOLS:
7/16" Nut Driver
7/8" and 1-1/8" Wrenches
THE FOLLOWING PROCEDURE IS TO BE PERFORMED BY
QUALIFIED PERSONNEL ONLY
1. Remove bottom panel to access pivot.
HEIGHT
ADJUSTMENT
PIVOT
JAMB NUT
ADJUSTING
2. Gap between top of door and frame , and between bottom
of door and frame must be approximately equal
Adjust height of door by loosening jamb nut, then turning
pivot on its screw mounting. Clockwise lowers the door
height. Re-tighten jamb nut .
3. Gap between left side of door and frame must be the
same from top to bottom
Adjust door for plumb by loosening holding screws. Turn
adjusting bolt to increase or decrease gap at bottom.
Clockwise increases gap. Re-tighten holding screws.
4. Gap between top of door and frame must be the same
from side to side
Adjust door for level by loosening holding screws, then
raising or lowering latch-end of door until it is level.
Re-tighten holding screws.
5. Reinstall bottom panel.
Procedure is complete
13
L E
V E
L
HOLDING
SCREWS
IL2259
B
U M
P L
BOLT