Jumper Setup - ASROCK EP2C612 WS User Manual

2.7 Jumper Setup

he illustration shows how jumpers are setup. When the jumper cap is placed on
the pins, the jumper is "Short". If no jumper cap is placed on the pins, the jumper
is "Open". he illustration shows a 3-pin jumper whose pin1 and pin2 are "Short"
when a jumper cap is placed on these 2 pins.
SATA DOM Power Jumper
(3-pin SATAPWR_SEL1)
(see p.6, No. 22)
SATA DOM Power Jumper
(3-pin SATAPWR_SEL2)
(see p.6, No. 35)
Consult the documentation that comes with your SATA DOM and check whether or not
Pin 7 requires 5V power supply.
If the connected SATA DOM requires 5V power supply, move the jumper caps placed on the
SATA DOM Power Jumper (SATAPWR_SEL1 or SATAPWR_SEL2) from pins 2-3 (default)
to pins 1-2.
If the connected SATA DOM does NOT require 5V power supply, connect the SATA DOM
power cable to the SATA DOM power header (SATA_PWR_1) and there is no need to
change the default jumper setting of the SATA DOM Power Jumper (pins 2-3).
Warning! Incorrect setting of the SATA DOM Power Jumper (SATAPWR1) may cause dam-
age to the motherboard or your SATA DOM.
SATA DOM (SSATA_3)
requires 5V power supply
SATA DOM (SSATA_2)
requires 5V power supply
EP2C612 WS
SATA DOM (SSATA_3)
does NOT require 5V power
supply (Default)
SATA DOM (SSATA_2)
does NOT require 5V power
supply (Default)
25