Table of Contents
Advertisement
2.6 Jumper Setup
The illustration shows how jumpers are setup. When the jumper cap is placed on
the pins, the jumper is "Short". If no jumper cap is placed on the pins, the jumper
is "Open". The illustration shows a 3-pin jumper whose pin1 and pin2 are "Short"
when a jumper cap is placed on these 2 pins.
Chassis ID Jumper
(3-pin CHASSIS_ID0)
(see p.6, No. 29)
PCIE2 Selection Jumpers
(3-pin PE8_SEL)
(see p.6, No. 27)
(3-pin PE16_SEL)
(see p.6, No. 26)
PCIE2 Selection Jumpers
(3-pin PE8_SEL)
(see p.6, No. 27)
(3-pin PE16_SEL)
(see p.6, No. 26)
26
Board Level SKU (Default)
- PCIE2 runs at x16
- M2_1/SATA_4_7/OCU1/
OCU2 Disabled
(Deafult)
- PCIE2 Disabled
- M2_1/SATA_4_7
Disabled
- OCU1/OCU2 Enabled
Reserved for system level
use
- PCIE2 runs at x8
- M2_1/SATA_4_7 Enabled
- OCU1/OCU2 Disabled
- PCIE2 Disabled
- M2_1/SATA_4_7/OCU1/
OCU2 Enabled
Advertisement
Table of Contents
