Table of Contents
Advertisement
2.6 Jumper Setup
The illustration shows how jumpers are setup. When the jumper cap is placed on the pins,
the jumper is "Short". If no jumper cap is placed on the pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1 and pin2 are "Short" when a jumper cap is
placed on these 2 pins.
NCSI Mode Jumper
(3-pin NCSI_SEL1)
(see p.6, No. 53)
OCP3 +12VSB Power Jumper
(3-pin +12VSB_SEL1)
(see p.6, No. 32)
Chassis ID Jumper
(3-pin CHASSIS_ID0)
(see p.6, No. 41)
22
NCSI for X710/I210
(Default)
Enable +12VSB for OCP3
PWR (Default)
Pull-up, for BMC further
use (Default)
NCSI for OCP NIC
Disable +12VSB for OCP3
PWR
Pull-down, for BMC further
use
Advertisement
Table of Contents
