Placing A Call On Hold - Siemens OpenStage15 Operating Manual

Enhanced phone functions
Step by step
Hold ?
Reconnect ?
Retrieve held call ?
Disconnect ?
64

Placing a call on hold

You can use this function to place an ongoing call on
hold, for instance, to prevent the other party overhear-
ing a conversation with a colleague in the same room.
The "Hold" function must be activated by the service
personnel.
Prerequisite: You are conducting a call.
f
Select and confirm the option shown.
Retrieving a held call
l
Select and confirm the option shown.
Using line keys
On multi-line telephones you can use the line keys to
place ongoing calls on hold.
R
Press the corresponding line key. The line key LED
starts flickering. The call is now on hold.
Retrieving a held call:
T
Press the corresponding line key. The line key LED
lights up. The call is retrieved.
The LED display
call is on hold to other multi-line telephones
where this line is also configured. These phones
can then pick up the call.
Held call wait status
After placing a call on hold, you can replace the handset
and then decide if the call should be retrieved or discon-
nected.
Prerequisite: You placed a call on hold and replaced the
handset.
l
Select and confirm the option shown to resume the call
in speakerphone mode.
or
f
Select and confirm the option shown to disconnect the
call.
page 20 indicates that the