Answering Calls With The Trunk Keys; Dialing With Trunk Keys; Placing A Call On Hold On A Trunk Key And Retrieving The Held Call - Siemens HiPath 2000 Operating Instructions Manual

Step by Step
if nec.
if nec.
\
Making calls in the team/ executive/secretary configuration

Answering calls with the trunk keys

Prerequisite: Your telephone rings or the trunk key
flashes quickly.
T
Press the trunk key that is flashing quickly.
(not necessary if "Prime Line" is active).
^
Lift the handset.
or On-hook dialing: Speakerphone mode.

Dialing with trunk keys

S
Press the free trunk key you wish to use to establish the
connection
(not necessary if "Prime Line" is active).
j
Dial the phone number.
^
If the party does not answer: Lift the handset.
or On-hook dialing: Speakerphone mode.
Placing a call on hold on a trunk key and
retrieving the held call
Prerequisite: You are conducting a call via one of your
group's trunks. The "Hold" key has been programmed
on your telephone
Hold
S
Press the "Hold" key.
if nec.
s
or
Replace the handset or press the disconnect key.
Depending on the configuration (contact your service
personnel), this may be necessary so other team mem-
bers can also pick up the call on hold.
Retrieving the call
T
Press the trunk key flashing slowly.
page 68.
101