6.4
Aqua Prima
Operating logic with "AQUA PRIMA" filter.
When use of the "aqua prima" filter is selected on the user menu or via the control panel, the
system water count logic is as follows:
If the "aqua prima" function is enabled the electronics perform a pulse count of the turbine,
recording one pulse every 2 revolutions.
If the "aqua prima" function is disabled, the electronics perform a pulse count of the turbine,
recording one pulse every revolution.
The graph in the figure below illustrates this function:
Aqua Prima
on
Aqua Prima
off
= 1 pulse
TALEA Section 06
REV00 - August 06
Ideas with Passion
360°
360°
1 rev
1 rev
Turbine revs
360°
360°
1 rev
1 rev
3/6